DIY Modern Bulletin Board

 

Learn how to make a DIY modern bulletin board using a few tools and supplies.

Steps

Step 1: Take your fabric and wrap it taut around the plywood.

Plywood

Carefully wrap the fabric around the edges and staple it against the back of the plywood using a hand staple gun. Pull it tight to ensure it’s smooth on the right side. Cut off any excess from the back. One tip is to pull in the corners so that it has the smoothest edge possible. The larger the bulk of fabric, the more difficult it is to have your wood trim sit flush at the edges.

Step 2: Using the Bernzomatic TS8000, burn the wood trim.

Wood trim

This particular torch is designed for a multitude of projects. It torches the wood quickly and creates the perfect charred look without much effort. The fully adjustable flame and pressure regulator made it ideal for this particular type of project.

Step 3: Measure the sides of the bulletin board and cut the strips of wood.

Wood strips

Tip: Recommend cutting the strips a little larger and trimming them down one at a time right before you nail them in.

Step 4: Add a polyacrylic coat to the trim pieces.

Clear coat

When charring the wood, it will leave a lot of black residue on the wood. Taking a piece of cloth, rub on some polyacrylic. This creates a smooth look, removes excess residue and gives it a nice protective finish on the wood.

Step 5: Install the wood trims to the plywood using a brad nailer.

Brad nailer

Measure one side at a time and then attach that particular piece of trim to the edge of the plywood. Use a brad nailer to attach the trim and have it sit flush against the edges.

Step 6: Attach sawtooth hangers to the back of the plywood.

Hangers

You will need a way to hang the bulletin board so attach two sawtooth hangers. Hang it up on your wall and enjoy your new, one of a kind, modern bulletin board! The possibilities are endless with the variety of fabrics out there.

Bulletin board

What You'll Need


TS8000
TS8000

Max Heat Torch for Faster Work Times

Learn More

MG9
MG9

14.1 oz. MAP-Pro™ Hand Torch Cylinder

Learn More

Materials

  • Strips of wood for the trim
  • Large sheet of plywood (mine was less than an inch thick)
  • Fabric of choice
  • Sawtooth hangers
  • Gloves
  • Polyacrylic
  • Cloth

Tools

  • Brad Nailer
  • Hammer
  • Staple Gun
  • Miter saw or something similar to cut the wood
Community Projects

#findyourfire

Share Your Project

No, Thanks Close