How to Solder Copper Pipe

Solder Copper Pipe

TS8000-Max Heat Torch for Faster Work Times




Soldering copper pipe is a plumbing project most people can do themselves with a Bernzomatic torch and just a few essential, inexpensive materials.

  • Soldering is a technique used most frequently for plumbing repairs and installations, but can also be used to create jewelry, connect circuit wires or automotive repair.
  • Solder should be melted by the heat of the metal pieces being joined, not by direct contact with the flame of the torch.


  • Read our General Safety Precautions in the Information Center before starting your project.
  • See our Lead-Free Soldering techniques guide for more tips for soldering new lead-free fittings.
  • Read the instructions that come with your torch and solder before beginning your project.
  • The torch flame should be blue when soldering
  • Always remove torch from fuel cylinder and store fuel in an upright position after completing your project.


CATEGORY: Construction


  • TS8000-Max Heat Torch for Faster Work Times
  • Bernzomatic 14.1 oz. MAP-Pro™ Hand Torch Cylinder
  • Keep a fire extinguisher or water source nearby in case of emergency.
  • Safety glasses
  • Wet cloth
  • Work gloves


  • Brush
  • Copper pipe & fittings
  • Flux
  • Soldering wire
  1. Step 1Brush the outside of the pipe and inside of the fitting thoroughly with an abrasive, such as sandpaper, the Bernzomatic S4N1B Four-in-One Pipe Fitting Brush or Bernzomatic SCSYD Water Resistant Sand Cloth .
  2. Step 2Brush flux onto the inside of fitting the outside of pipe, then slide the pipe and fitting together.
  3. Step 3Ignite the torch. Heat the entire joint evenly until the solder can be melted by the heat of the joint, rather than the flame of the torch. Move the torch to the far end of the joint.
  4. Step 4Touch the solder to the joint. When the joint is hot enough, the solder will be drawn into the joint, creating a seal.